Select Page

FireHoist™ FGH

Commercial Fire Door Operators

Raynor FireHoist FGH fire door operators offer 1/2 HP, 1 HP, 1-1/2 HP, 2 HP, and 3 HP inline gear reducer option providing for an integrated fire door system. Resetting of the operator is as easy as reconnecting the fusible link release cable and then activating the open control to reset the door.

The FGH models are also available for retro-fitting existing fire doors by eliminating all the components that typically fail with an operator. Other release devices can be added to the system for detector/alarm inputs and loss of power.

FireHoist™ FGH operators feature:

  • Solenoid actuated disc brake
  • TENV motor
  • 30 cycles per hour
  • Fusible link activation of internal release and governor controlled closing
  • Auxiliary hand chain ( up to 2 HP)
  • On-board open, close, stop buttons
  • On-board non-resettable cycle counter
  • Optional on-board timer to close

Standard Features on all FireHoist Operators:

  • cULus Listed
  • NEMA 1 enclosure
  • 24 volt control circuit
  • 3- button open/close/stop
  • Solid state control board
  • Overload protection
  • Continuous duty motor
  • Adjustable Linear Driven Limit Switches
  • Optional monitored reversing device and unmonitored reversing device
  • Delay on reversing
  • Average speed 6″ to 8″ per second

Product Details

Operation Mode In-line gear reducer
Duty Cycle 30 cycles per hour
Operational Speed 8″ to 12″ per second
Drive Gear
Environmental Options NEMA 1
Motor Continuous Duty – 1/2, 1, 1-1/2, 2, and 3 hp
Logic Solid State
Power 115/230 1ph, 230/460/575 3ph
Brake Solenoid brake
Wiring Options Fire door mode or conventional commercial operator mod

Optional Accessories


McCabe Link
Reusable device reacts to heat or local smoke detector, alarm system, or manual activation.

  • 115V AC/DC
  • 24V AC/DC



LM21 Releases
Provides fail-safe release of the door during a power loss. LM21 models are available with adjustable alarm and power loss delay.
Models: XP, XPBB, AFCB


Smoke Detectors
Heat, ionization (smoke only) or photoelectric (smoke and heat) detectors trigger release devices to drop your door in case of fire.

  • 115V AC
  • 24V DC

Product Literature

FireHoist™ Warranty

Raynor warrants the electrical operator and component parts for two (2) years against defects in material and workmanship.

Under the terms of this limited warranty, for any operator components that are found to be defective upon inspection by authorized Raynor personnel, Raynor will, at its option, repair or replace the defective door components. Labor charges for installations or repairs shall be the responsibility of the consumer and must be performed by an authorized Raynor Dealer. This warranty applies only to doors that are professionally installed by an authorized Raynor Dealer.

This warranty extends only to the original purchaser. This warranty is not transferable.

This warranty does not apply to any damage or deterioration caused by abuse or failure to provide reasonable and necessary maintenance.

Raynor shall not be liable for any consequential or incidental damages.

ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY OF MERCHANTABILITY, ARE HEREBY EXPRESSLY EXCLUDED.

Some states do not allow the exclusion or limitation of consequential or incidental damages, so the above limitation or exclusion may not apply to you.

Claims for defects in material and workmanship covered by this warranty shall be made in writing with proof of purchase to the dealer from whom the product was purchased or call Raynor at 1-800-4-RAYNOR within the warranty period. Raynor may choose to have the product returned for inspection.

This warranty gives you specific legal rights. You may also have other rights, which may vary from state to state.